MVW 681 Bedienungsanleitung Geschirrspüler instruction book dishwasher Seite 2 page 23
Contents Safety instructions 24 Disposal 24 Economical and ecological dishwashing 24 Installation instructions Building-in Levelling Fixing to adjacent units Water supply connections Water inlet hose with safety valve Water outlet hose connection Electrical connection 25 25 25 25 25 25 26 26 Description of the appliance 27 The control panel Audible signals 28 29 Prior to using for the first time Setting the water softener Filling with dishwasher salt Rinse aid 30 30 31 32 In daily use Loading
Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water supply connections This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we advise you a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes a lot. Remove all packaging before positioning the machine.
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following ways: Information concerning the electrical connection is given on the rating plate on the edge of the dishwasher’s door. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. Before plugging the appliance into the wall socket, make sure that: 1.
Description of the appliance 1. Upper basket stop 2. Water hardness dial 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11.
The control panel Delay start button Function buttons Cancel button Digital display On/Off button Programme selection buttons 3 in 1 button Half load button Function buttons: in addition to the selection of the washing programme and the "half load", the following functions can also be set with the help of these buttons: Indicator lights "3 in 1" button: This appliance is equipped with the option 3 in 1, that allows the use of the "3 in 1" combi detergent tablets.
Audible signals Audible signals have been introduced to help indicate which operations the dishwasher is performing: "Setting of the water softener" "End of programme" "Something not working with the machine" Deactivation/activation of the audible signals (The dishwasher must be switched off) Factory setting: audible signals activated 1. Press the On/Off button.
Prior to using for the first time Before using your dishwasher for the first time: b) Setting electronically (The dishwasher must be switched off) 1. Ensure that the electrical and water connections comply with the installation instructions. The dishwasher is factory set at level 5. 2. Remove all packaging from inside the appliance. 1. Press the On/Off button.
Filling with dishwasher salt Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion. To fill: 1.
Rinse aid ● Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting. If you are using dishwasher detergent that already contains rinse aid, the detergent including the rinse aid must be placed in the detergent compartment.
In daily use ● Check if it’s necessary to refill with dishwasher salt or rinse aid ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. ● Before loading the dishes, you should: - Remove large left-overs.
The cutlery basket The upper basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces.
Adjusting the height of the upper basket Use of detergent If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution.
Different kinds of detergent Detergent tablets Detergent tablets from different manufactures dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals.
Washing programmes Programme Degree of soil and type of load (2) Consumption values Water consumption (in litres) 0,1 4 * half load Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying 1,7 - 1,9 23 - 25 * half load Cold prewash Main wash up to 65°C 2 warm rinses 1 hot rinse Drying 1,5 - 1,7 23 - 25 Light soil. Crockery and cutlery Main wash up to 65°C 1 hot rinse 0,8 9 Normal soil.
Starting a washing programme In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. 5. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it’s absolutely necessary 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely Attention! Hot steam may escape when the door is opened. Open the door carefully.
"3 in 1" function This function can be selected together with all programmes. Place the 3 in 1 combi detergent tablet in the detergent dispenser. Press the "On/Off" button. Press the 3 in 1 function button, the correspondent indicator light illuminates. Remember that if this function is selected, it will remain active also for the following programmes, until it will be deactivated by pressing the 3 in 1 function button (indicator light off). Select the required washing programme.
Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...a flashing fault code appears The dishwasher will not start or stops during operation. The intervention of an alarm is indicated by a sequence of intermittent audible signals.
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes" chart).
Boretti B.V. De Dollard 17 - 1454 AT - Watergang. www.boretti.nl