MVW 680 Bedienungsanleitung Geschirrspüler instruction book dishwasher
Contents Safety instructions 22 Disposal 22 Economical and ecological dishwashing 22 Description of the appliance 23 The control panel 23 Prior to using for the first time Setting the water softener Filling with salt Rinse aid 25 25 26 26 In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent 27 27 27 28 28 28 29 Different kinds of detergent 29 Washing programmes 30 Starting a washing programme
Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety.
Description of the appliance 1. Upper basket stop 2. Water hardness switch 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11.
Audible signals Audible signals have been introduced to help indicate which operations the dishwasher is performing: "Setting of the water softener" "End of programme" "Something not working with the machine" Deactivation/activation of the audible signals (The dishwasher must be switched off) 1. Press the On/Off push button. The indicator lights of the programme selection push buttons will illuminate and in the digital display are visible 2 horizontal lines (--) (setting mode). 2.
Prior to using for the first time Before using your dishwasher for the first time: b) Setting electronically 1. Ensure that the electrical and water connections comply with the installation instructions (The dishwasher must be switched off) 2. Remove all packaging from inside the appliance The dishwasher is factory set at level 5. If it’s necessary to set a new level, proceed as follows. 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with salt 1.
Filling with salt Adjusting the dose Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
In daily use ● Check if it’s necessary to refill with special salt or rinse aid ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. Loading cutlery and dishes ● ● Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher.
In case that plates are loaded in the upper basket: The cutlery basket Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door.
Use of detergent Fill with detergent Only use detergents specifically designed for use in dishwashers. Using no more then the correct amount of detergent contributes to reducing pollution. Prior to the start of a wash programme (not for the "Rinse and Hold" programme). The detergent is released during the washing phase. Please observe the manufacturer’s dosing and storage recommendations as stated on the detergent packaging. (Detergent dispenser type A) 1. If the lid is closed: press release button (1).
Washing programmes Programme Degree of soil and type of load Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) 12 0,1 4 1. Rinse and Hold Any. Partial load (to be completed later in the day). 1 cold rinse (to avoid food scraps from sticking together) 2. Intensive 70°C Heavy soil. Crockery, cutlery, pots and pans Warm prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying 85 - 95 1,65 - 1,85 22 - 24 3.
Starting a washing programme In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. To cancel a washing programme in progress Open the dishwasher door. Press simultaneously the function push buttons 2 and 3 for about 2 seconds, the indicator lights of the programme selection push buttons start flashing for about 2 seconds.
7. End of the washing programme The dishwasher will automatically stop and 3 intermittent audible signals of about 15 seconds each, alternated one from another with a pause of 3 minutes, inform you of the end of the washing programme. Hot steam may escape from the appliance when opening the door immediately after the end of the programme, therefore, open the door carefully. The end of programme indicator light is illuminated. Switch off the dishwasher by pressing the On/Off push button.
Maintenance and cleaning NEVER try to remove the upper spray arm. Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick. Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...a flashing fault code appears The intervention of an alarm is indicated by a combination of flashing indicator lights, audible signals and a visible fault code in the digital display, as indicated in the following chart. Carry out the following suggested corrective actions.
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Do not use, for connection, old hoses which have been used in another appliance. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. Remove all packaging before positioning the machine.
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following ways: Information concerning the electrical connection is given on the rating plate on the edge of the dishwasher’s door on the right. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. Before plugging the appliance into the wall socket, make sure that: 1.
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes" chart).
Boretti B.V. De Dollard 17 - 1454 AT - Watergang. www.boretti.nl