Instructions / Assembly

ASSEMBLY

Accessories

If your bike is supplied with a water bottle and cage, attach the cage to the

bicycle using the Allen bolts provided.

Some bikes come equipped with a saddlebag or frame bag. The

saddlebag installs under the seat with the zipper facing the rear wheel.

Undo the straps that wrap around the bag, thread them through the rails

underneath the seat and secure around the bag. The smaller strap wraps

around the seat post. Frame bags install at the apex of the top and seat

tubes. Secure the straps around each tube.

NOTE: The frame bag straps must not bind the cables. The straps must

go around the frame only.

Other: Some 20” and 24” model bicycles come with a rear derailleur guard

to protect the rear derailleur from damage. To install, remove the rear

wheel axle nut on the drive side, install the rear derailleur guard over the

axle with the U-shaped guard pointing down, and retighten the axle nut.

The guard will sit between the frame and the axle nut.

If provided with a handlebar mounted reflector, this reflector must be

mounted as close to the center of the handlebar as possible.

Reflectors

Attach the white reflector to the front reflector bracket and secure to the

handlebar or fork using the hardware provided. Attach the red reflector to

the rear reflector bracket and secure to the frame or seat post, depending

on the bracket style, with the hardware provided.

Tighten both rear wheel axle nuts and the quick release

mechanism securely. Failure to do this may cause the

rear wheel to dislodge from the frame dropouts resulting

in serious damage or injury.

Saddle Bag

Frame Bag

Reflector

Water bottle and cage