Specifications

ManualsBrandsM2 ManualsAmplifier6M-1K2

800-777-0703 I DXENGINEERING.com

8080

XEXEXE

CW & Digital Modes

SignaLink™ PC/Radio

Sound Card Interface

The all-new SignaLink USB combines

the legendary performance of the original

SignaLink SL-1+ with a state-of-the-art,

built-in low-noise sound card. All sound

card digital and voice modes are supported by the SignaLink USB. This includes

traditional modes such as RTTY, SSTV and CW, as well as today’s hottest new modes like

PSK-31, MT-63 and EchoLink®. The front panel controls let you adjust your Transmit Audio,

Receive Audio and Transmit Delay on the fly.

The SignaLink USB needs just one USB connection to the computer and one connection

to the radio (in most cases). Convenient front panel controls make setup and operation

very easy. The SignaLink USB is fully isolated and is compatible with all radio Mic, Data,

and Accessory ports. The SignaLink USB allows you to use your computer’s sound card for

other functions while enjoying digital communications.

Just order the correct, fully-assembled interface cable for your radio(s) and simply “plug

and play.” Cables are available for a Mic connector interface or rear DIN plugs on radios

so equipped. It makes for a neat, clean installation!

• Easy to set up • Works with all radios

• Just plug in two cables • Powered through USB cable

• So ware included • Easy hookup to Macintosh or PC

• Built-in sound card • Comprehensive, easy-to-follow instructions

TGR-SL-USB SignaLink USB unit ................................................................ $84.50

Any cable only $14.95 (except special Elecra K3 cable)

when ordered with TGR-SL-USB. Order one cable for each radio.

SignaLink™

Radio Interface Cables

Pick the correct radio interface cable for either a Mic

connector interface or rear DIN plugs on radios so

equipped. Some radios do not have the “RX Audio”

signal on the Mic connector and will require a mono

cable to be installed between the SignaLink USB and the radio.

This is never an issue if you attach the SignaLink to your radio’s Data or Accessory port.

TGR-SL-CAB4R 4-Pin Round Mic Connector Interface Cable ....................... $19.95

TGR-SL-CAB8R 8-Pin Round Mic Connector Interface Cable ...................... $19.95

TGR-SL-CABRJ1 RJ-11 Mic Connector Interface Cable................................... $19.95

TGR-SL-CABRJ4 RJ-45 Mic Connector Interface Cable................................... $19.95

TGR-SL-CAB5PD 5-Pin DIN Interface Cable ...................................................... $19.95

TGR-SL-CAB8PD 8-Pin DIN Interface Cable ...................................................... $19.95

TGR-SL-CAB13I 13-Pin DIN Icom Interface Cable .......................................... $19.95

TGR-SL-CAB13K 13-Pin DIN Kenwood Interface Cable .................................. $19.95

TGR-SL-CAB6PM 6-Pin Mini-DIN Interface Cable ............................................. $19.95

TGR-SL-CABNC Unterminated Cable Interface Cable ..................................... $9.95

TGR-SL-CABK3 Special Elecra K3 Interface Cable ...................................... $19.95

TGR-SLHEAD Header Plug for Radio Programming .................................... $7.95

Preprogrammed “Plug and Play” Radio Jumper Modules

TGR-SL-MOD13I Jumper Module, Icom 13-Pin Accessory Port ....................... $7.95

TGR-SL-MOD13K Jumper Module, Kenwood 13-Pin Accessory Port ............... $7.95

TGR-SL-MOD6PM Jumper Module, 6-Pin Mini-DIN ............................................. $7.95

TGR-SL-MOD8PD Jumper Module, 8-Pin DIN ..................................................... $7.95

Digital Modes +

Rig Control Interface!

West Mountain Radio RIGblaster Advantage

Connect the RIGblaster Advantage to your radio’s microphone connector, and a

computer USB connector and you’ll have access to over 100 existing and future ham

radio sound card so ware programs! You’ll also get over 20 exciting modes that radio

could not otherwise operate. The Advantage also links your computer so ware and radio

using CAT, CI-V or DB9 interfaces cables.

WMT-58012-1288 RIGblaster Advantage ......................................................... $199.95

WMT-58107-971 RIG Control Cable for CI-V (Icom & TenTec) Radios .............. $9.95

WMT-58108-974 CAT Cable for Yaesu FT-736/747/767/990/1000 .................... $9.95

WMT-58108-972 CAT Cable for Yaesu FT-100/100D/817/857/897 .................... $9.95

WMT-58214-1295 RIGblaster DB9F to DB9F Serial Cable .................................. $9.95

WMT-58012-1288

MFJ-407D

Curtis Deluxe Electronic Keyer

Using cutting-edge microprocessor control,

the MFJ-407D gives you iambic key operation

and dot-and-dash memory to help you send perfect code. You can

adjust code speed, weight and side tone frequency, plus this keyer is

compatible with your key, single or dual paddle.

MFJ-407D Curtis Deluxe Electronic Keyer ............................................. $79.95

MFJ-464

CW Keyer/Reader

Build your ultimate CW station! You can

send CW or load messages with your

paddle, keyboard or your computer’s serial

port. The MFJ-464’s AutoTrak feature locks

on, tracks and displays CW up to 99 WPM.

Using this keyer is easy, thanks to its large LCD screen, intuitive interface and internal

speaker. You can repeat messages, adjust from normal to Farnsworth spacing, insert

pauses and even embed commands to automatically change weight or speed.

MFJ-464 CW Keyer/Reader Unit ......................................................... $189.95

MFJ-495

Millennium CW

Memory Keyer

With the MFJ-495, you get a feature-laden

keyer with dual microprocessors and

nonvolatile EEPROM chip for excellent

reliability. You can key in CW with your paddle,

keyboard or through a computer serial port. MFJ-495’s battery backed-up

memory allows you to store messages and settings. This user-friendly keyer

also features an internal speaker and simple interface, which makes it easy to set up

and start sending CW.

MFJ-495 Millennium CW Memory Keyer ........................................... $169.95

QSL 7"

Digital Picture

Frame and Scanner

This kit, consisting of one digital scanner and one 7" digital picture frame, is the perfect

way to digitally capture and display your QSL Cards or 4" x 6" photos.

Simply feed your QSL cards through the scanner, then transfer the scanner’s SD

memory card to the digital picture frame. It’s a great way to preserve the cards and

remember QSOs, while showing o your collection. Over 3,000 QSL cards can be stored

and displayed. The XYL will be happy to see the wall again, and you’ll have more room to

hang certificates!

DXE-QSL-KIT .............................................................................................................. $89.95

CW50A Electronic Keyer

The Palstar CW50A Electronic Keyer has a speed control adjustable from 10 to 40 WPM,

crystal-controlled for high accuracy. You can easily flip from mode A to mode B iambic

keying and the built-in sidetone generator and speaker make monitoring your transmis-

sion easy. The CW50A also doubles as a training unit. Character spacing and dash weight

are adjustable, as well.

The Palstar CW50A Electronic Keyer works with any straight key, semi-automatic bug key,

single lever paddles and iambic dual lever “squeeze” paddles. Plus, it’s compatible with

both tube and solid state rigs. You can hook up your paddle through a convenient front

panel jack, and there’s a separate jack for your straight key—allowing for two keys to be

attached at the same time! Read more details at DXEngineering.com.

• Sidetone pitch: 500-1000 Hz, front panel adjustable

• Keying output: positive, negative, and high-speed reed relay

• Operating current: 10-50 mA, depending on sidetone level

PAS-CW50A Palstar Electronic Keyer ........................................................$159.95