User's Manual

05
07
If a defect arises during the warranty period, we will either 1) replace the defective product with
a new and undefective one with your consent, or 2) refund the original purchase price. This
warranty excludes damage resulting from abuse, accident, modifications, unauthorized repairs
or damage that are not related to defects in materials and workmanship.
Attentions
1.Please use the product with the designed voltage. An improper voltage may damage the product
and cause injury.
2.Please do not disassemble products .
3.Do not use the product in extreme temperatures.
4. Radio signals in the installation area may interfere signal transmissions of the product.
Statement
The copyright of this manual belongs to M2Micro Co., Ltd. all rights reserved.
Without authorized written permission issued by M2Micro, any organization or individual cannot
change, imitate, copy or translatedesign and content of this manual.
Applying this manual in any form, including but not limited to formats of hard copies, electronic
copies, photocopies, or audio and video recordings, to any commercial or profitable usage is
prohibited.
More information
This is a quick guide of the Garage Door Control System product.
If you would like to get more information or help, please download a detailed user manual from
our website (www.m2micro.com), or contact our technical support (Tel. : [phone],
Email: [e-mail]).
06
4. Set-up door sensor
Set-up the door sensor per to the instructions in the App.
Flip the sensor 90° and hold its trigger for 5 seconds. (See the picture below)
An message “Add garage door sensor successfully ” will pop up when the door sensor has been
set-up successfully and working normally.
5. Install door controller
Before set-up the system, the controller should be restored to the factory settings.
08
Seconal garage doors
One-piece lt garage doors
Place on the wall with the
double-sided tape fastening strip
Your garage door switch/wall console
Cable
Door 1 Door 2
Red cable
White cable
Reset to factory default
To reset the controller, press and hold the Reset button on the device until you hear a beep sound,
and see indicators flashing green.
6. Install door sensor
Place the door sensor in the upper portion of the garage door with the "THIS SIDE UP" label facing
to the ceiling (arrows pointing up) and the battery compartment facing the garage door. Assure
the sensor is in the horizontal position when the garage door is open.
Reset
Connect the door controller to the original wall switch of the garage door. (see the picture below)
Warranty
M2Micro offer a one-year limited warranty to this product. Your door controller & door sensor are
warranted against defects in materials and workmanship for a period of one year from the date of
the purchase.
What’s in the box
Door controller Door sensor Power supply
2 x Cables 2 x Cable connector 2 x AAA Batteries