User guide

68
Figure 2.1 VisualINI
Figure 2.2 Device setup
Figure 2.3 Side key setting
In the StartUp window, user must set the correct device model then, click ‘OK’ button to confirm it. Before
going to the next step, the device must go through soft reset. Then, launch StartUp again to customize the
keys.
From figure 2.2, go to MM3SideKey window for key customization. MM3 SideKey customization window is
shown in figure 2.3. Check 'INSTALL' if you want to keep the settings even after hard reset.
Note that from figure 2.3, SHIFT and ESC drop down menus are disabled because the screen shot is taken
using MM3 with 55-key keypad. If 41-key version is used, BACKSPACE and TAB will be disabled and SHIFT
and ESC fields are activated.
FKey Enable is available in B1ST(O/H)V645EN or later version. FKey Enable option is put in to the OS to
make MM3 useful with Telnet programs such as IBM 5250/ IBM 3270 which uses F1 to F24.
This is why VK_M3SCAN is introduced. The default value of SCAN button is F14 which cannot be used in
IBM 5250/ IBM 3270. When SCAN KEY is set to M3SCAN, the scanner will not work with M3 ScanEmul or
ScanTest application.
If FKey is enabled, user can use F1 to F24 on green layer. Please refer to below MM3-5250 keypad.
Note that it has F1 to F24 on green layer on ‘C’ to ‘Z’.