Timer Camera F ESP32 TimerCAM Timer Camera X 2020 V0.
1. OUTLINE Timer Camera F is a development board for image recognition. It features an ESP32(4M Flash + 520K RAM) chip and 2-Megapixel carmera(OV2640). Timer Camera F offers plenty of storage, with an extra 4 Mbyte PSRAM. It also supports image transmission via Wi-Fi and debuging through USB Type-C port. ESP32 TimerCAM and Timer Camera X feature an 2-Megapixel carmera(OV3660). 1.
Timer Camera F Camera Image Sensor:OV2640 Maximum resolution: 200w pixe FOV:160°l ESP32 TimerCAM Camera Image Sensor:OV3660 Maximum resolution: 200w pixel FOV:65.5° Timer Camera X Image Sensor:OV3660 Maximum resolution: 200w pixel FOV:65.5° 2. PIN DESCRIPTION 2.1. USB INTERFACE Configuration Type-C type USB interface, support USB2.0 standard communication protocol. 2.2. GROVE INTERFACE 4p disposed pitch of 2.0mm GROVE interfaces, internal wiring and GND, 5V, GPIO4, GPIO13 connected.
3. FUNCTIONAL DESCRIPTION This chapter describes the ESP32-D0WDQ6-V3 various modules and functions. 3.1. CPU AND MEMORY ESP32-D0WDQ6-V3 contains two low-power Xtensa ® 32-bit LX6 MCU.
3.3. CRYSTAL • ESP32-D0WDQ6-V3 40 MHz crystal oscillator. 3.4. RTC MANAGEMENT AND LOW POWER CONSUMPTION ESP32 uses advanced power management techniques may be switched between different power saving modes. (See Table 5). • Power saving mode - Active Mode: RF chip is operating. Chip may receive and transmit a sounding signal. - Modem-sleep mode: CPU can run, the clock may be configured. Wi-Fi / Bluetooth baseband and RF - Light-sleep mode: CPU suspended.
4. ELECTRICAL CHARACTERISTICS 4.1. LIMIT PARAMETERS Table 8: Limiting values VIO to the power supply pad, Refer ESP32 Technical Specification Appendix IO_MUX, as SD_CLK of Power supply for VDD_SDIO. Press and hold the side power button for two seconds to start the device.Press and hold for more than 6 seconds to turn off the device. Switch to the photo mode through the Home screen, and the avatar that can be obtained through the camera is displayed on the tft screen.
ESP32 TimerCAM/Timer Camera F/Timer Camera X Quick Start With preloaded firmware, your ESP32 TimerCAM,/Timer Camera F/Timer Camera X would run right after power on. 1. Power on the cable into ESP32 TimerCAM/Timer Camera F/Timer Camera X by USB cable. Baud rate 921600.
2. After waitting for a few seconds, Wi-Fi scan a AP named "TimerCam" with your computer(or mobile phone), and connect it. 3. Open up the browser on the computer(or mobile phone), visit the URL http://192.168.4.1:81. At the moment, your can see the real-time transmission of video by ESP32TimerCam/TimerCameraF/TimerCameraX on the browser.
A Bluetooth name "m5stack" is found on the mobile phone_ BLE”， Connect to this name to establish a data transmission channel。
