Technical information

38
10. MULTIMODE AFM
SAFETY PRECAUTIONS
Ortiz Nanomechanics Lab : 13-5037
I. TIPHOLDERS :
•
••
• Only use the AFM tipholders provided with the
Multimode, do not use any early-model AFM tipholders
from older AFM's, they may short out the power supply.
II. LASER :
•
••
• During and prior to laser alignment, avoid looking
directly at the laser beam, the laser spot, or reflected laser
light-especially with highly reflective samples. Staring at the
laser beam can cause eye damage.
•
••
• Do not manipulate highly reflective samples while the
laser in on.
•
••
• Never plug in the laser unless the head is secured on
top of the base with the piezo springs.
III. FLUIDS
•
••
• Do not operate the standard tipholder in fluids.
Standard tipholders have exposed electrical signal lines that
could cause a short circuit if exposed to a conducting fluid.
•
••
•When imaging in fluids use extraordinary precautions
against spillage on any component of the AFM. Fluids
must not be spilled on or around the sample stage, electronic