Installation Instructions

inner roller

track

outer roller

track

OUTSIDE

TUB / SHOWER STALL

TUB / SHOWER LEDGE

INNER

GLASS PANEL

OUTER

GLASS PANEL

WALL

CHANNEL

To install the Outer Glass Panel, face the Rollers toward the outside. HOLD

THE GLASS PANEL BY THE SIDES and lift up into the underside of the

Header. Be certain that both Rollers are resting on the outer roller track.

Slowly release, allowing the Glass Panel to hang from the Header.

Slide the Outer Glass Panel away from the shower head end of your Tub.

The edge of the Glass Panel should touch the Bumper. If not, the wall is not

plumb & the Glass Panel needs to be adjusted. To adjust, remove the Outer

Glass Panel and move one or both Rollers into other holes. Re-install Glass

Panel and re-check for plumb.

Please note, the Glass Panels need to be hung as low as possible to avoid

water from “splashing-out”. There should be a slight gap between the bottom

of the Glass Panel and the Center Guide.

WARNING: DO NOT LIFT GLASS PANELS BY THE TOWEL BARS.

Install the Inner Glass Panel first. With the Rollers facing toward the Tub,

HOLD THE GLASS PANELS BY BOTH SIDES and lift up into the underside

of the Header.

Be certain that both Rollers are resting on the inner roller track. Slowly

release, allowing the Glass Panel to hang from the Header. Slide the Inner

Glass Panel towards the shower head end of your Tub. The edge of the

Glass Panel should touch the Bumper, if not, the wall is not plumb & the

Glass Panel needs to be adjusted. To adjust, remove the Inner Glass Panel

and move one or both Rollers into other holes. Re-install Glass Panel and

re-check for plumb.