Installation Instructions

GAP
1
2
Locate the Track in the center of the Tub / Shower Enclosure ledge.
Maintain a uniform gap, at each end, between the end of the Track and the wall.
The “HIGH SIDE” on the Track is located towards the outside.
Using masking tape, temporarily secure the Track to the ledge and mark the location with a pencil.
DIMENSION D
At this point, re-measure the wall-to-wall distance, dimension “D” and re-check
subtraction, to be certain of the correct Track Dimension.
“Measure twice, cut once”.
Measure the “Track Dimension” along the length of the Track. Carefully cut the Track
to fit the Tub / Shower Enclosure.
Please note, to obtain the best results, use a 32-tooth per inch hacksaw blade and
miter box.
3
TRACK PROFILE
M
ASKING TAPE
WARNING: SAFETY GLASSES SHOULD BE WORN AT ALL TIMES.
Measure the finished wall-to-wall distance, dimension “D”, in the center of the
Tub / Shower Enclosure ledge.
If a steel tape is used, be sure to add the width of the case to the measurement.
Subtract 3/16” from dimension “D”, this is your “T
RACK DIMENSION”.
HIGH SIDE
Install End Guide at the end of the Track as shown in SKETCH 3A.
Note: In SKETCH 3A a section of the Track has been cut away to clearly show the installation of the End Guide.
END GUIDE
SKETCH 3A
TRACK AND END GUIDE PROFILE