Installation Instructions

8
Install Rollers as shown.
Please note, the Spacer Nut, on the Roller, is mounted against the Hanging
Bracket.
Initially, install the Roller in the middle mounting hole. The other holes are available
as needed for adjustments.
For the Outer Glass Panel, the Rollers are mounted on
the same side as the Towel Bar as shown.
For the Inner Glass Panel, mount the Rollers on the opposite
side from the Door Handle as shown.
OUTER GLASS PANEL
INNER GLASS PANEL
Glass Panel
End View
SPACER
NUT
ACTUAL SIZE #8 X 7/16”
LONG MACHINE SCREW
12
Glass Panel
End View
Pealing away only one side of the Double-Faced Tape protective cover, install two tape pieces to the bottom of the Center Guide as
shown in SKETCH 9A. Make sure to leave space for applying the Silicone Sealant as noted. DO NOT remove the remaining
protective tape cover at this time.
To install the Center Guide, locate the middle of the track as shown in SKETCH 9B. Insert the Center Guide as shown in SKETCH 9A
,
without removing the protective cover, and mark it’s proper position on the Track.
Once the position is marked, remove the Center Guide and peal away the remaining protective cover on the Double-Faced Tape.
Reinstall the Center Guide at your marked position on the Track and apply Silicone Sealant.
SKETCH 9A
9
SPACE TO APPLY SILICONE
SEALANT AFTER THE CENTER
GUIDE HAS BEEN INSTALLED.
SKETCH 9B
INSTALLED POSITION
TO INSTALL
MIDDLE OF TRACK
11
12
12
11
12
12
11
11
16
18
16
18