Installation Guide

14
Install the side wall (15) with the drilled faucet hole(s).
Lift the wall approximately 3" above the threshold of
the base, push it completely against the back wall
then lower the side wall into position.
Quick tip 
With a 1/8" bit, drill holes in the side wall fastening flange
(15) at the top aligned with each stud. Only pre-drill
the flange not the studs. Then, secure the side wall
(15) with one #8 x 1¼" screw (not included) in one of the
pre-drilled holes.
IMPORTANT: HAND TIGHTEN ONLY. DO NOT
OVER-TIGHTEN THE SCREW.
3
1
Side wall
Back wall
Base
Side wall
BEFORE CONTINUING,
VALIDATE THAT ALL
THE WALLS ARE LEVEL,
PLUMB AND SQUARE
5
STEP Temporary installation of
the side walls (Cont'd)
The side wall should now line up
with the front of the base.
Make sure the retraction pins are
properly inserted in the X
fasteners. There should be no gap
between the walls.
Quick tip 
Place a level
vertically on the side
wall. If the wall is not
straight, make sure
that the x-fasteners
are properly inserted
5.6
Check me!
5.7
Check me!
5.8
Check me!
Threshold