Installation Guide

17
7
STEP Final installation of side walls (cont'd)
Secure the walls to the wall studs with #8 x 1¾ "
screws (not included) in the previously drilled holes.
Also, secure the walls by the fastening fl anges on the
sides of the walls. Use the pre-dilled holes.
If needed, use shims to keep walls plumb, square
and leveled. (Cut shim excess)
IMPORTANT: HAND TIGHTEN ONLY. DO NOT
OVER-TIGHTEN THE SCREWS.
Check me!
Check me!
Place the template in the corner of the shower where
you want to install your shelf.
Slide the template up until the points on the left and
right-hand side of the template are at the height you
want your shelf.
Use a pencil, marker or wax pencil to mark the spots
where the holes for the shelf will be drilled.
Drill the holes using a 9/64" drill bit.
8
STEP Marking and drilling the
glass shelf holes
Fold here
Drilling positions
Base
Side wall
THE SIDE WALLS SHOULD LINE UP WITH
THE BASE
Quick tip 
90°