Installation Guide

7
2
STEP Installing the base
B3 / Olympia
Apply a 1/8" width silicone bead around the edge of
the drain hole in the base (refer to illustrations).
Assemble as shown.
HAND TIGHTEN ONLY !
VERIFY THE MAAX LOGO ON THE DRAIN COVER
IS FACING THE RIGHT WAY
REMOVE EXCESS SILICONE!
Install the base (13) pushing it completely against the
back studs. Center the base left to right inside the
alcove leaving equal spacing on both sides.
Centering the base left to right is
critical for side wall installation.
Top view
13
Remove clear plastic fi lm on the base. Use
cardboard on the base fl oor as protection until
the installation is complete.
Top view
Flush
2.1
Check me!
2.2
Check me!
Cardboard
Rubber
Studs
Threshold