Installation Guide

STEP Final installation of back wall

Quick tip 

Hold the bottom of the back wall

with your foot when fastening in

place.

⅜"

Bathtub

Back

wall

min.3/16"

max.3/8"

Stud

X fastener

It is critical for the side wall

installation for there to be at least

⅛'' and no more than ⅜" between

the stud and the X fastener.

6.1

Check me!

6.3

Check me!

6.4

Check me!

Remove all walls from the structure.

Clean the bathtub and apply a bead of silicone on the

deck at 3/8" from the back fastening flange. Run the

bead of silicone the entire length of the bathtub and 1''

on each side as well.

6.2

Check me!

Apply a bead of silicone on both sides of base (13) thres-

hold at 3/8" from the base side fastening flanges.

Apply silicone on both side of the back wall (14) just

before the wall side radius. The silicone applied on the

base and vertically on the back wall must overlap.

Secure the wall to the wall studs with #8 x 1¾ "

screws (not included) in the previously drilled holes.

Also, secure the wall by the fastening ﬂ anges on the

side of the wall. Use the pre-dilled holes.

If needed, use shims to keep wall plumb, square

and leveled. (Cut shim excess)

IMPORTANT: HAND TIGHTEN ONLY. DO NOT

OVER-TIGHTEN THE SCREWS.

⅜"