Installation Guide

9
If no studs are behind the wall covering use the wall
anchors when fastening the wall jambs.
S’il n’y a pas de montants derrière le mur, utiliser les
ancrages afin de fixer les montants muraux.
Si no hay montantes detrás del revestimiento, use
anclajes para sujetar las jambas murales.
3
D
A
B
!
HOLES INSIDE
TROUS À L'INTÉRIEUR
HUECOS INTERIOR
!
A. Remove the wall jambs from the frame. Place them on the
previosly marked positions and verify that they are
leveled. Mark the position of the wall jamb fastening holes on
the shower walls. Remove the wall jambs.
B. Drill the holes on the previously marked positions.
C. Apply a bead of silicone at the bottom on the inside of each
wall jamb.
D. Place the wall jambs on the shower walls, ll the holes with
silicone and fasten with the provided screws.
A. Enlever les montants muraux du cadre. Le mettre sur
les emplacements marqués précédemment et valider qu'ils
sont de niveau. Marquer la position des trous de xation
des montants muraux. Enlever les montants muraux.
B. Percer les trous marqués précédemment.
C. Appliquer un cordon de silicone au fond à l'intérieur de
chaque montant.
D. Mettre les montants muraux sur le murs de douche, rem-
plir les trous avec du silicone et xer avec les vis fournies.
A. Quitar los montantes murales del marco. Colocarlos sobre
las paredes de la ducha alineados en las posiciones pre-
viamente marcadas y verique que están a nivel. Marcar la
posición de los oricios de jación de los montantes murales.
Retirar los montantes.
B. Perforar los huecos en las marcas hechas previamente.
C. Aplique un cordón de silicona en la parte inferior en el
interior de cada montante mural.
D. Colocar los montantes sobre los muros de ducha, llenar
los huecos con silicona y jarlos en posición con los tornillos
suministrados.
C