Installation Guide

Measure the finished wall-to-wall distance,
dimension “D”, in the center of the tub threshold
as shown in SKETCH 3A.
Please note: If a steel tape is used, be sure to add the width of
the case to the measurement. Subtract 1-5/16” from
DIMENSION
“D”, this is your “T
RACK DIMENSION
”.
At this point, re-measure the wall-to-wall distance,
“
DIMENSION D”, and re-check subtraction to be certain of the
correct Track Dimension.
“Measure twice, cut once”
Measure the “Track Dimension” along the length of the Track.
Carefully cut the Track to size.
Please note, to obtain the best results, use a 32-tooth per inch
hacksaw blade and a miter box.
SKETCH 3A
3
D
IMENSION
D
2
WARNING: SAFETY GLASSES SHOULD BE WORN AT ALL TIMES.
Determine if your Tub / Shower Enclosure ledge is level & walls
are plumb as shown in SKETCH 2A.
If they are out of level / plumb by more than 1/2”, stop and call
Customer Service.
A Ledge Filler and / or Wall Filler is recommended for obtaining
proper adjustment.
Both are available through Customer Service for a nominal
charge.
SKETCH 2A
4
OUTSIDE
TUB / SHOWER
STALL
T
RACK PROFILE
Install Track End Caps (with Corner Adapters, if necessary) on
to the ends of the cut piece of Track as shown in SKETCH 4A.
Place Track with installed Track End Caps on the tub threshold
and check for correct length. Re-cut if necessary.
A slightly loose fit is acceptable since the ends of the Track are
hidden within the Track End Caps.
SKETCH 4A
Right Track End Cap
Left Track End Cap
6
2
8