Installation Guide

INSTALL TRACK & WALL CHANNELS
After drilling holes, clean the tub threshold and the Wall Channel
areas thoroughly.
This will ensure proper adhesion of the silicone sealant.
Before installing the Track, apply silicone sealant as specified in
SKETCH 8A.
- Apply 3 beads of silicone sealant as shown when
Corner Adapter is installed.
- Apply 1 continuous bead of silicone sealant as shown
when Corner Adapter is not installed.
- Apply continuous beads of silicone sealant into the
SILICONE GROOVES located on the underside of the
Track as shown in SKETCH 8A.
Position the Track on the tub threshold, aligning it with the pencil
mark from the previous step.
R
EMEMBER, the high side of the Track must be placed toward the
outside of the tub threshold.
Install Wall Channels using the #10 x 1-1/4” Screws and Bumpers
provided as shown in SKETCH 8B.
1 continuos bead
of silicone sealant
Silicone sealant
3 beads of
silicone sealant
10
ACTUAL SIZE #10 X 1 1/4” LONG SCREW
SKETCH 8A
SKETCH 8B
PRE-FIT WALL CHANNELS
Carefully position the Wall Channel by sliding it down on to the
Track End Cap as shown in SKETCH 7A.
The “
SHORT LEG” of the Wall Channel should face the inside of the
shower as shown in SKETCH 7B.
Be careful not to move the temporary position of the Track.
Use a level to plumb the Wall Channel as shown in SKETCH 7C.
Mark the two mounting hole locations of the Wall Channel.
Repeat this procedure for the other Wall Channel.
Remove Wall Channels and Track. Drill marked mounting holes.
Size of holes are as follows;
When mounting to ceramic tile, use a 1/4” masonry drill bit. Nick
the ceramic surface at the mounting hole locations with a center
punch. After drilling, insert Wall Anchors.
When mounting to a fiberglass enclosure, use a 1/8” drill bit.
Wall Anchors are not required.
HIGH SIDE
OUTSIDE
INSIDE
TRACK PROFILE
SKETCH 7A
SKETCH 7C
SKETCH 7B
7
8
INSIDE
OUTSIDE
SHORT LEG
FACES INSIDE
SHORT LEG OF
WALL CHANNEL
For reference:
The hidden part of
the Track End Cap
shown in DASHED lines
WALL
LEVEL
9
10
Track End Cap
with Corner
Adapter installed
Track End Cap
without Corner
Adapter installed
Track