Owner`s manual

29
En g l i s h
Fr a n ç a i s
29 CALIFORNIA COOPERAGE
NOTE: If your source water has a high metal or mineral content, a specialty chemical should
be used to avoid staining or accumulation of deposits. These guidelines cover the most
common water problems when operating a spa with ozone. Contact your dealer for further
information regarding chemical control issues.
COMMON HARDWARE PROBLEMS
Problem
System not
operating
Heater not
operating
Water not clean
Abnormal
water usage
Overheating
Low water ow
from jets
Usual Cause
- House circuit breaker tripped or in
OFF position
- Water level too low - Heater mode
not selected - No power to heater
- Heater not operating
- Clogged or blocked oor suction of
skimmer - Filter clogged (dirty) - Poor
water chemistry - Insucient ltering
time - Improper maintenance
- High content of solids in water
- Excessive evaporation and/or
splashing
- High ambient temperature
- Operating in FILTER mode-low speed
- Clogged or blocked suction or skim-
mer - Dirty lter - Jets in OFF position
- Slice valves closed
Solution
- Reset circuit breaker on house
breaker panel
- Add water to reach ll line on
Weir door - Refer to temperature/
heater functioning. See Control
instructions pg. 16 - Check house
circuit breaker - Contact dealer
- Clean oor suction/skimmer. Re-
move blockage - Clean of replace
- See Maintenance section pg. 20
- Run ltration mode longer
- Contact dealer - See
Maintenance section, pg. 23 - Use
clarier or drain and rell spa
- Use spa cover and rell as
necessary
- Contact dealer
- Select hi-speed jets - Clean oor
suction/skimmer. Remove block
age - Clean or replace - Open jets
- Contact your dealer