Owner`s manual

En g l i s h
Fr a n ç a i s
30 CALIFORNIA COOPERAGE
Problem
No water ow
from jets
Noisy pump
and motor
Water leakage
from under spa
No air ow
from jets
Motor will
not operate
The spa will
not shut o
Usual Cause
- Pump not primed - Adjustable jets
turned o - House circuit breaker
tripped, no power to system - Faulty
pump or motor - Pump surges - Slice
valves closed
- Clogged oor suction of skimmer
- Low water level - Damaged or worn
motor bearings
- Check unions & drain hoses
- Air control not open - Jet nozzle not
seated properly - Jet nozzle missing
- House circuit breaker tripped or in
OFF position - Improper or defective
wiring or electrical supply - Thermal
Overload Protection switch tripped
- Spa trying to heat - Spa is in lter
cycle - Spa is in standard Mode
Solution
- See Priming section, pg. 15
- Turn on jets - Reset circuit
breaker at house panel - Contact
dealer - Low water. Check level
on Weir door - Contact your dealer
- Clean oor suction/skimmer
- Add water to normal water level
(6” below lip) - Contact dealer
- Close or tighten as necessary
- Open control - Check jet nozzles
- Inspect jets and replace as
needed
- Reset circuit breaker - Contact
dealer - Auto reset after motor
has cooled. Contact dealer if
motor continues to cycle
- Check ‘Set Temperature’ in
Standard Mode - Normal. No
need to change - Check mode
setting