Owner`s manual

FIG. 2 4-CHANNEL MODE

Connect and set the amplifier as shown in Fig. 2 if it is to be controlled by a car radio with four output channels

and used with four loudspeakers:

(1) To the car radio, front left output

(2) To the car radio, front right output

(3) To the car radio, rear left output

(4) To the car radio, rear right output

(5) Front left loudspeaker

(6) Front right loudspeaker

(7) Rear left loudspeaker

(8) Rear right loudspeaker

FIG. 3/4 3-CHANNEL MODE

The 3-channel mode uses the high-pass filter for channels 1/2 and the low-pass filter for Channels 3/4. Section

5 describes how they are used.

FIG. 3

Connect and set the amplifier as shown in Fig. 3 if it is to be controlled by a car radio with stereo output and

used with stereo satellite loudspeakers and a subwoofer.

(1) To the car radio, left output

(2) To the car radio, right output

(3) Left satellite loudspeaker

(4) Right satellite loudspeaker

(5) Subwoofer

FIG. 4

Connect and set the amplifier as shown in Fig. 4 if it is to be controlled by a car radio with stereo receiver and

separate subwoofer output and used with stereo satellite loudspeakers and a subwoofer.

(1) To the car radio, left output

(2) To the car radio, right output

(3) To the car radio, subwoofer output

(4) Left satellite loudspeaker

(5) Right satellite loudspeaker

(6) Subwoofer

FIG. 5 2-CHANNEL MODE

If the amplifier has to generate more power to operate two subwoofers, connect and set it as shown in Fig. 5.

The use of the low-pass filter used is described in Chapter 5.

(1) To the car radio, left output

(2) To the car radio, right output

(3) Subwoofer

(4) Subwoofer