User manual

13
Installing the digital-TV-box
The first time you install your digital-TV-box or when you move to another
region or move the box to another cable-TV-provider, a few settings under
the menu “Installation – Network configuration” need to be changed. The
two settings that are to be changed are Network number and Frequency.
Information about these two settings is obtained from your cable-TV-operator.
OBSERVE! To be able to set up the box, a valid smart card needs to be placed
in the left-hand card reader.
The digital box is ready to be used as soon as the installation procedure
described on the following pages is completed.
INSTALLATION
Press the MENU-key to display the basic menu.
Select
INSTALLATION with the navigation keys up/down.
Press the
OK-key to confirm your choice.
To protect the installation menus, these are locked and can only be opened
with a so-called “secret code”. This code is factory pre-set to “0000”.
INSTALLATION CODE
Enter your secret code, the factory-set default code is “0000”. The first
segment flashes until a digit is entered and the second begins to flash
etc. As soon as the digit is entered a star replaces the segment.
Using the left arrow button on the remote control, it is possible to
return and modify a digit already entered before the complete code is
confirmed by pressing the
OK- key. In this case the digit becomes a
flashing segment again, indicating that a new digit may be entered.
If the code entered is incorrect, the following error message is displayed
on the screen. Then re-enter the code and press
OK to confirm.
You may change the default code “0000”: se on page 17.
When the correct code is entered you gain access to the installation
menu.
– – – –
INSTALLATION
CONFIRM RETURN QUIT
ENTER YOUR INSTALLATION CODE
THEN PRESS OK TO CONFIRM
R
Q
OK
M008-1Fh
INSTALLATION
MOVE CONFIRM RETURN QIUT
R
Q
OK
NETWORK CONFIGURATION
TV AND VCR INSTALLATION
MODULATOR INSTALLATION
CHANGE INSTALLATION CODE
OPERATING INDICATORS
LANGUAGE SELECTION
LOCAL TIME SETTINGS
M009-1Fh
– – – –
CHANGE INSTALLATION CODE
CONFIRM RETURN QUIT
PLEASE RE-ENTER YOUR NEW CODE
THEN PRESS OK TO CONFIRM
R
Q
OK
FALSE ENTRY
CONFIRMATION
START AGAIN
M016-3Fh
CHANNEL LIST
RADIO LIST
INFORMATION
INSTALLATION
MAIN MENU
MOVE CONFIRM QUIT
Q
OK
M001-4Fh
INFORMATION
If you have displayed a menu and not made any changes for a
while, the brightness is automatically turned down to save the TV-
screen from wear. Press any key to get the picture back to normal.
USER MANUAL DCB-101
SECTION 7