Owner's manual

Form # 46620 Issue 01/06

SAFETY

SAFETY SIGNS

· The safety signs reproduced below appear on the header at the locations listed.

· Keep safety signs clear and legible at all times.

· Replace safety signs that are missing or become illegible.

· If original parts on which a safety sign was installed are replaced, be sure the repair part also bears

the current safety sign.

· Safety signs are available from your Dealer Parts Department. The part number is printed in the

lower R/H corner of each safety sign.

To install safety signs:

1. Be sure the installation area is clean and dry.

2. Decide on the exact position before you remove the backing paper.

3. Remove the smaller portion of the split backing paper.

4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is

applied.

5. Small air pockets can be smoothed out or pricked with a pin.