User guide

SECTION UA – UNLOADING AND SETUP

Form 169365 UA-6 Issue – May 2008

III. ADJUSTING AXLE SPACING – TWO &

THREE AXLE

a. Loosen four bolts (D) on underside of axle to be

moved.

b. Loosen two bolts (E) on topside of forward axle.

c. Loosen outer nuts on the forward axle adjuster

rod (F).

d. Turn inner nuts on adjuster rod (F) so that left

and right frames separate slightly from main

beam.

e. Remove adjuster rod (G) on rear axle.

f. Remove the four bolts (H) on both sides of rear

axle mount (J).

g. Slide axle to new location and line up rear axle

mounting holes (K).

h. Re-install four bolts removed at step e. on both

sides of rear axle mount and tighten.

i. Re-install adjuster rod (G) in adjuster plate and

tighten.

j. Tighten all remaining nuts.