User guide

SECTION UA – UNLOADING AND SETUP

Form 169365 UA-8 Issue – May 2008

STEP 3. SET UP COMBINE HITCH

– THREE-AXLE ONLY

The combine hitch can be configured in two

lengths depending on the combine and header

size. The longer hitch is for combines where

there is insufficient clearance between the rear

of the combine and the header reel when

rounding corners.

CAUTION

Towing the transporter with a truck when

the combine hitch is installed is not

recommended for highway travel. If

necessary, a pintle type hitch should be

installed on the truck and the transporter

combine hitch (p/n 113566) in place of the

clevis type hitch.

a. Detach tow-bar from storage position on

transporter.

b. Ensure stop-bolt (A) is installed.

c. Position combine tow-bar (B) inside channel (C)

under existing hitch in either long or short

location. Illustration shows long setup.

d. Install two bolts and castle nuts (D) to secure

combine hitch to channel. Secure castle nuts

with cotter pins.

e. Install receptacle bracket (E) onto lugs on hitch

with hardware provided.

f. Attach wiring receptacle to bracket with

hardware provided.

g. Secure wiring to lugs on hitch with clamps and

hardware provided at four locations (G).

h. Connect plug from transporter to receptacle on

combine hitch.