User's Guide

To charge your MBTBUDS simply connect the USB
end of the charging cable to a USB charging
adapter (adapter not incuded) and the Micro USB
end into the MBTBUBS charging port. While
charging, the battery status LED will stay solid red
and then turn to white when fully charged.
Charging LED status indicator:
• Red: Charging
• White: Fully charged
Charging the MBTBUDS
Music Playback
• Volume Up/Next Song button
Press and release to increase the volume
Press and hold to skip to the next song
• Volume Down/Previous Song button
Press and release to decrease the volume
ress and hold to skip back to the previous song
• Play/Pause button
Press and release to play/pause your music as
needed
Phone Calls
NOTE: During an incoming call your music will
pause automatically and resume playback when
the call has ended.
• Play/Pause button
Press once to answer the incoming call and a
second time when you wish to end the call.
To ignore the incoming call simply let it ring out.
• Volume Up/Next Song button
Press and release to increase the volume
• Volume Down/Previous Song button
Press and release to decrease the volume
Swapping out the ear buds and in-ear supports
The MBTBUDS includes 3 different sized Ear buds
and in-ear supports (S, M, L). To swap them out,
simply pull off the existing set and attaché a
different sized one as needed. When re-attaching
the in-ear support, make sure it sits up on the
opposite side of the cable as shown in the images
below.
Pairing the MBTBUDS with iPhone, iPad or iPod
NOTE: The MBTBUDS may not be fully charged
when you get it. Please make sure you charge
them If the sync LED does not flash during pairing.
1. Separate the ear buds and make sure the
Bluetooth sync LED is flashing red/white. If it’s not,
press and hold the sync button on the headset for
three to four seconds until it flashes.
MBTBUDS BUTTONS AND ACTIONS
PAIRING THE MBTBUDS
Volume Up/Next Song
Volume Down/
Previous Song
Play/Pause
Bluetooth
sync button