Installation guide

4 HANG MOUNT BRACKET INSTALLATION

4.1 Component Installation

Hang mount bracket and its components are shown as below. See Figure 4-1.

Figure 4-1

4.2 Installation

4.2.1 Installation Requirements

The hang mount speed dome can be installed in the hard construction wall in the indoor or

outdoor environments. Before the installation, please make sure:

z The wall is thick enough to install the expansion bolt.

z The wall can at least sustain the 4x weight of the speed dome.

4.2.2 Installation Steps

Loosen the M4 bolt in the flange side to separate the flange and steeve. Pull the integration cable

through the airproof slot of the bottom of the flange and then connect to the centre hole of the

flange. Please secure the flange in the ceiling. See Figure 4-3. Please note, if the speed dome

is installed in the outdoor environments, you need to paste the silica gel on the surface of

the flange and the surface and the cable exit.

Figure 4-2

Figure 4-3

Silica gel

Connect to flange