Installation guide

1.2 Installation

Please note the quick installation speed dome includes the quick installation high speed dome,

IP quick installation speed dome, tracing quick installation high speed dome, quick installation

medium speed dome.

The speed dome has several types of installation brackets. You can refer to the following

contents for detailed information. Here we are going to install the speed dome in wall mount

bracket.

Open the transparent cover and take out the packing material

EPE around the speed dome driver.

Please remove the protective paster from the driver and take off the camera lens cap. See Figure

1-1.

Figure 1-1

1.2.1 Address and Baud Rate Setup

Now you can set the quick installation speed dome address and baud rate. The speed dome

interface is shown as below. See Figure 1-2. There are two dial switches: SW1 and SW2. Here

you can set the address, baud rate, communication protocol and etc. Please refer to chapter 1.4

for detailed information.

Figure 1-2