Instruction Manual

7/9/2013 CLUTCHBR_SHAFT_BRNZBUSH_MANUAL Page 5 of 5
D. REASSEMBLY
(1) Replace the piston/bearing/cone sub-assembly into cylinder.
(2) Inspect the inside diameter of the bearing in the air cylinder. If Loctite
®
residue is
present, gently scrape and assure that the surface is clean.
(3) Apply a thin coat of Loctite
®
#609 retainer compound to the inside diameter of the air
cylinder bearing, then slide the air cylinder/bearing sub-assembly over the drive hub.
Applying excessive Loctite
®
will make future disassembly more difficult.
(4) Replace the outer retainer ring. Invert clutch-brake and seat cylinder sub-assembly
firmly against retainer ring.
(5) Replace drive discs, friction discs and springs according to CLUTCH & BRAKE
FRICTION DISC & SPRING REPLACEMENTportion of these instructions.
(6) Replace the retainer rings, sleeve and races according to reference drawing.
(7) See CLUTCH INSTALLATION portion of these instructions for the proper procedure
for reinstalling the clutch-brake.
Technical assistance is available by contacting Mach III Clutch, Inc.
Mach III Product Warranty
http://www.machiii.com/Resources/Warranty-Info.asp
Mach III Clutch, Inc.
101 Cummings Drive Walton, KY 41094
Toll free 866.291.0849 ● International 859.291.0849 ● Fax 859.655.8362
info@machiii.com engineering@machiii.com www.machiii.com