User manual

Operation

Each unit must be set to the correct MIDI mode, from a choice of Multi,

Master or PCPort on the MIDI mode screen in the Utilities menu. The MIDI

mode setting for each device will depend on the protocol used and whether

synchronization between the units is required.

Note that all units connected via MIDI port will only be synchronized after a

MIDI dump has been performed. Units connected via RS232 do not require

a MIDI dump in order to synchronize, but if a MIDI dump is not performed,

each unit will contain different stored programs and current program settings

until changes are made to each setting individually on the Tx unit).

The default position for the MIDI dump screen is MIDI DUMP: NO. Use the

Parameter UP/DOWN keys to select YES on the Tx unit, then press STORE

at the prompt, to confirm the dump. A percentage complete figure on the Tx

screen will show how much data has been transferred. The Rx screen will

read Warning! Incoming Dump. When the dump is complete, the Tx screen

will default to NO. The Rx screen will display the name of the new current

program.

Notes that all parameter edits in all stored programs will be overwritten in

any CUSTOMER UNIT set to the same MIDI channel. Use MIDI Dump with

care!)

Delete program

This facility allows any stored program to be removed from the unit. Use the

Parameter UP/DOWN keys to select the desired program, and press

STORE to confirm deletion.

Note that programs marked M cannot be deleted from USER units.

Protocol Tx Rx Sync. Status

RS232 PCPort Multi -

RS232 PCPort PCPort -

RS232 Multi Multi -

RS232 Multi PCPort -

RS232 Master Multi Synchronized

RS232 Master PCPort Synchronized

MIDI Multi Master -

MIDI Master Master Synchronized after

dump.