User manual

Operation 17
INPUTS MENU
There are two inputs available for routing to outputs plus an internal mono
sum of inputs A and B, referred to as A+B. This gives the Input Channels: A,
B, and A+B.
The facilities described in this section are common to all inputs, except EQ,
which is not possible on the mono sum A+B signal.
Delay
The first screen in the input menu is the Delay screen. Pressing the RIGHT
key will access the EQ screens.
The delay on each input channel can be adjusted individually, in 22
microsecond steps by pushing the Parameter UP/DOWN keys. (Holding a
Parameter UP/DOWN key down will increment/decrement the amount of
delay in larger steps). This delay is typically used to set the delay for delay
towers etc., or to stagger the delays between the left and right channels to
'move' sound lobes in an installation.
Delays can be viewed and adjusted in metres (default), feet/inches, or
milliseconds.
Note that the maximum delay value is restricted by any delay on an output
that is fed by the current input.
Input delay and output delay for any signal path is limited to 630ms.
EQ
To add EQ to an input, step through the functions on the desired channel
using the RIGHT/LEFT keys until you reach the screen that shows the EQ
parameter you wish to edit. (See “EQ screens” on page 20 for more details).
OUTPUTS MENU
To select any of the output bands, press the UP/DOWN keys until the output
is shown on the screen.
Name
The first screen in the Output menu is the Name function. Here you can
identify each output with a name suitable to its function, selecting from a list
of names in the unit, such as SUB, or 2" HORN. Use the Parameter
UP/DOWN keys to select the desired name. If the name selected while