REV.00 15/07/05 COD.6000276.
Always switch off the appliance at the end of the work cycle, turn off the water and disconnect the power supply. INTRODUCTION 1) Read the instructions in this booklet carefully as they provide important information, use and maintenance. Keep the booklet to hand in a safe place so that it can be consulted by other operators. 2) After removing the packing material, check that all the equipment is present and intact. If there is any doubt, do not use it and contact qualified personnel.
1. TECHNICAL DATA 4 1.1 SCHEMATIC VIEW 5 1.2 ELECTRICAL DIAGRAM 6 2. INSTALLATION 8 2.1 CONNECTION TO POWER SUPPLY 8 2.1.1 GROUND 8 2.2 CONNECTION TO WATER SUPPLY 9 2.3 WATER DRAIN 10 3. INSTRUCTIONS FOR USE 12 3.1 START UP 12 3.1.1 WASHING PROGRAMMES 14 3.1.2 DETERGENT AND RINSE AID 14 3.2 CLEANING 15 3.3 IF THE DISHWASHER IS NOT USED FOR LONG PERIODS 16 4. IN CASE OF MALFUNCTIONS 16 5.
1. TECHNICAL DATA • The specifications tag (Fig. 1-1) is placed on the right-hand panel of the machine. It contains all the neccessary data to install the appliance. Fig.
1.1 SCHEMATIC VIEW Fig.
1.
Rif.
2. INSTALLATION • Installation, initial start-up and maintenance of the appliance must be carried out by qualified personnel only. All hydraulic and electrical connections must be carried out in compliance with current safety norms. The manufacturer accepts no responsibility for malfunctions arising from incorrect connection of the appliance. When installing, ensure that the appliance is perfectly level. Turn the adjustable feet clockwise or anticlockwise to level the appliance.
2.2 CONNECTION TO WATER SUPPLY • The appliance is designed for connection to the cold or hot water supply (max. 50 55°C) at a mains pressure with the valve open as shown in Table 2-1 and a minimum output of 10 litres/min. If pressure exceeds the maximum, fit a pressure reducer. If pressure is lower than the minimum, fit a pressure booster pump of max. 0.5 HP, with an output of 20 litres/min. and a head of 15÷20 metres. Pressure must be measured at the solenoid valve inlet (see fig. 2-4).
Fig. 2-4 WATER/CYCLE DRAIN FOR MAINS RINSE 2.5 litri 2.5 - 3 litri 2.5 - 3 litri 3 - 4 litri minimum very good for glass-washers good for dish-washers very good for dish-washers Fig. 2-5 2.3 WATER DRAIN • Connect the drain hose of the appliance to the outlet (D), fitting a siphon between the hose and the outlet. Alternatively, place the appliance over a drainage well (E), which should be fitted with a cover (F) to prevent the build-up of unpleasant odours.
Fig. 2-6 Fig.
Fig. 2-8 3. INSTRUCTIONS FOR USE • The appliance is designed to wash crockery. Use a suitable low-foam detergent. Plates and dishes should be scraped clean of residue, which might clog the drain and nozzles. Fill the basket carefully. N.B. : It is advisable to remove large food remains. The best results are obtained when the items are washed after pre-washing or soaking. 3.1 START UP • Turn on the water tap (B) and switch on the master switch (A).
RECOMMENDED TEMPERATURE boiler 90°C tub 60°C Fig. 3-1 Fig.
3.1.1 WASHING PROGRAMMES • When the water intake cycle is complete, open the door (I) and add detergent (about 2 g. per litre of tank capacity). Position the full basket (L) and close the door (I). Select the appropriate washing cycle by pressing button (3) (short cycle I button pressed, long cycle II button not pressed. Now press the START button (4) and the wash cycle displayed by light (D) will start. When the cycle is over, this light goes out. To turn off the appliance, turn the switch (1) to 0.
3.2 CLEANING • Cleaning is extremely important for proper operation of the appliance. We recommend cleaning at the end of each work cycle. Turn off the 0-I switch, wash all the removable parts in running water and replace them with care. WARNING : Before removing the filters (S) clean residual foreign matter from the bottom of the tub. N.B. : Turn off the master switch (A) before cleaning the outer coating, without using direct or high pressure water jets.
3.3 IF THE DISHWASHER IS NOT USED FOR LONG PERIODS • If the machine is not used for a long period, clean it carefully. Wash and dry the tub and the filters. Leave the door open while the machine is not in use. Turn off the water and disconnect the power supply. 4. IN CASE OF MALFUNCTIONS • In case of malfunctions, immediately switch off the appliance, turn off the water and disconnect the power supply. Call a service technician. 5.
Unit 7, Church Park, Lowfield Heath, Crawley, West Sussex RH11 0PW Sales: 01293 571199 ▪ Fax: 01293 571133 Email: sales@mpswholesale.co.uk ▪ www.mpswholesale.co.