User Manual

Page 5-28
200 BENCH PROCEDURES
FIRE RING GROOVE CUTTING PROCEDURE
Refer to Figure 5-29.
1. Place cutter base (1) on cylinder head (2).
Insert hold-down capscrews into appropriate
mounting holes (per application) until hold-
down capscrews bottom out in mounting
holes.
Figure 5-29 — Cutter Base Alignment
Refer to Figure 5-30.
2. Position cylinder head so threaded section
of hold-down capscrews can be reached.
Install spacer (3), washer (2) and wing
nut (1). Lightly tighten wing nut.
The cutter base must be free to move.
Figure 5-30 — Fastening Cutter Base
1. Cutter base 2. Cylinder head
200288a
1
2
1. Wing nut
2. Washer
3. Spacer
200289
a
1
2
3
5-101.bk Page 28 Friday, March 17, 2006 11:05 AM