User Manual

200 BENCH PROCEDURES
Page 5-39
Figure 5-50 — Removing Injection Nozzle Holder Insert
INJECTION NOZZLE HOLDER INSERT
INSTALLATION
1. Thoroughly clean insert bore and
surrounding area before installing insert.
2. Apply Loctite 620 completely around the
center of all three sealing diameters of the
new insert.
Refer to Figure 5-51.
3. Using nozzle sleeve installer J 29297 (2),
drive insert (1) into cylinder head until it
bottoms in lower counterbore face.
Figure 5-51 — Injection Nozzle Holder Insert Installation
[213 FH] Valve Yoke Guide Pins
The valve yoke guide pins are located between
valve guides.
INSPECTION
Inspect valve yoke guide pin surface for cracks or
other damage. Also check pin diameter and
installed height.
1. Slide hammer
J 2619-01
2. Sleeve puller J 29880
200306a
1
2
1. Insert 2. Nozzle sleeve installer
J 29297
5-101.bk Page 39 Friday, March 17, 2006 11:05 AM