User Manual

Page 6-36
200 ENGINE ASSEMBLY
Installation
After resurfacing, any flywheel with drilled
balance holes on the clutch side requires
rebalancing by a machine shop.
When installing the flywheel, insert two alignment
studs into the flywheel mounting holes to aid in
installation.
Refer to Figure 6-41.
1. Position the flywheel on the rear of the
crankshaft at the flywheel mounting surface.
2. Install flywheel mounting capscrews in the
exposed mounting holes. At this time,
tighten the capscrews finger tight only.
3. Remove the two alignment studs and insert
the remaining mounting capscrews.
Do not torque capscrews adjacent to each other
in sequence as uneven flywheel alignment may
result. Alternately torque capscrews on opposite
sides of the flywheel.
4. Torque the capscrews to 185 lb-ft (251 N폷m),
alternating from opposite sides to apply
even pressure to the flywheel (use torque
wrench J 24407 or equivalent).
Figure 6-41 — Flywheel Installation
5-101.bk Page 36 Friday, March 17, 2006 11:05 AM