User Manual

Page 6-40
200 ENGINE ASSEMBLY
7. Lubricate camshaft journals and camshaft
bearing surfaces (in cylinder block) with
clean engine oil.
Do not rotate camshaft with the installation tool in
position on the shaft. The tool must remain on the
bottom of the shaft (6 o’clock position) or it will not
function properly.
8. Carefully insert camshaft into the block with
the camshaft installation tool in place. Align
timing marks on the camshaft with timing
mark on the main crankshaft drive gear.
Refer back to Figure 6-45.
The use of the installation tool will make it easy to
slide the camshaft into the block while protecting
the cam and bushings from damage.
Refer to Figure 6-48.
9. Secure camshaft captured thrust washer to
the block using the two patch-lock 12-point
capscrews (3) and hardened washers.
Torque to 15 lb-ft (20 N폷m) using torque
wrench J 24406 or equivalent.
Figure 6-48 — Camshaft Installation
10. Remove the camshaft removal/installation
tool.
1. Thrust washer
2. Openings
3. Capscrew, 12-point
4. Camshaft drive gear
200365a
1
2
3
3
4
5-101.bk Page 40 Friday, March 17, 2006 11:05 AM