User Manual

200 ENGINE ASSEMBLY
Page 6-69
9. Torque the three lower support bracket-to-
cylinder block capscrews to 40 lb-ft
(54 N폷m) using torque wrench J 24407 or
equivalent.
Figure 6-86 — Support Bracket-to-Cylinder Block
Capscrews
10. Torque the two upper support bracket-to-fuel
injection pump capscrews to 15 lb-ft
(20 N폷m) using torque wrench J 24407 or
equivalent. Loosen and then retorque the
capscrews to 40 lb-ft (54 N폷m).
Figure 6-87 — Torquing Upper Support Bracket-to-Fuel
Injection Pump Capscrews
11. Loosen the two link-to-support capscrews at
least two full turns. Then retorque link-to-
support capscrews to specification.
Refer to Section 7, SETUP AND ADJUSTMENTS,
Fuel Injection Fixed-Timing procedure, for steps to
be used in setting fuel injection pump-to-engine
timing.
200450a
200451a
5-101.bk Page 69 Friday, March 17, 2006 11:05 AM