User Manual

200 SPECIFICATIONS
Page 2-7
TORQUE SPECIFICATIONS
This section includes specifications for torquing all critical and standard non-critical fasteners.
Torque Specifications for Critical Fasteners
Description
Torque
Lb-Ft N•m
Air compressor-to-cylinder block screw 70 95
Auxiliary driveshaft gear nut (front) 300 dry 407
Auxiliary driveshaft hole cover stud nut 40 54
Auxiliary driveshaft thrust washer-to-block screw 15 20
Brake harness adapter (at cylinder head) 8a 11
Brake (Dynatard)
Brake hydraulic lash adjuster retainer nut 27a 37
Brake solenoid to adapter 8a 11
Brake solenoid adapter to rocker arm shaft 24a 33
Brake (Jacobs)
Cylinder head cover/spacer capscrews 20 27
Electrical connector 57
Engine brake hold-down capscrew 45 61
Oil supply screw 57
Rocker arm adjusting screw jam nut 40 54
Rocker arm bracket hold-down capscrew 40 54
Slave piston adjusting screw nut 17 23
Throttle switch actuating arm 55 (lb-in) 6
Yoke leveling screw jam nut 33 45
Buttress screw 90 122
Camshaft thrust washer-to-block screw 15 20
Centrifugal oil filter drain fitting stud nut 40 54
Clutch cover-to-flywheel screw 40 54
Connecting rod screw 150 203
Coolant conditioner-to-water fitting screw 15 20
Crankcase drain plug 55 75
Cylinder head breather-pipe-to-cylinder-head cover screw 15 20
Cylinder head capscrew 205 278
Cylinder head cover screw 16 22
Econovance assembly-to-cylinder block screw 40b 54b
Econovance control valve and cover plate-to-Econovance screw 180 lb-inb 20b
Econovance diagnostic port cap 125 lb-inb 14b
Econovance thrust washer retaining screw 150b 203b
a
English threads.
b
V-MAC applications.
5-101.bk Page 7 Friday, March 17, 2006 11:05 AM