User Manual

Page 2-10

200 SPECIFICATIONS

Torque Specifications for Hose Clamps

V-MAC components (cont.)

Lower support bracket-to-cylinder block capscrews 40 54

Upper support bracket-to-injection pump capscrews 15 20

Timing event marker (TEM) 22 30

V-MAC 7-pin pump connector 15 20

Bracket-to-block capscrews 40 54

Hose clamp screw 15 20

RPM/TDC (engine position) sensor (jam nut) 15 20

MPH (road speed) sensor (jam nut) 15 20

Engine oil pressure sensor 6 8

Intake manifold temperature sensor 23 31

Coolant temperature sensor 23 31

Coolant level sensor 23 31

Bulkhead connector (jackscrew) 5 7

V-MAC module connector (jackscrew) 2 3

V-MAC ELAB valve terminal nut 3 4

Fuel injection pump actuator connector 15 20

Electrical equipment panel mounting leg hardware 6 8

Electrical equipment panel accessory studs 2 3

Timing solenoid to Econovance (four bolts) 15 20

Water manifold screw 25 34

Water pump cover-to-water pump housing screw 15 20

Water pump shaft locknut 90 122

Water pump-to-cylinder block screw 60 81

Torque Specifications for Critical Fasteners (Cont.)

Description

Torque

Lb-Ft N•m

English threads.

V-MAC applications.

Hose Clamps

Torque

Lb-In N•m

SAE J536 Type F

Air inlet systems 38 4

Water or coolant systems 28 3

Oil drain systems 28 3

Hi-torque heavy-duty worm clamp 80 9

T-bolt type hose clamp 50 6

NOTE: The band of any hose clamp in all installations should be a minimum of 0.090 inch (2.290 mm) from the end of the hose

and must be clear of tube bead.

5-101.bk Page 10 Friday, March 17, 2006 11:05 AM