User Manual

200 ENGINE DISASSEMBLY
Page 4-5
[271 CB] ALTERNATOR
Refer to Figure 4-3.
1. Loosen adjusting capscrew (2) and
mounting nuts (6).
2. Remove drive belts (1) and tag belts for
reassembly.
3. Disconnect and tag electrical wires by
removing mounting hardware.
4. Remove mounting nuts (6) and washers.
Pull out capscrews (3) and remove
alternator (7).
5. Remove alternator plate (5) by removing
mounting hardware (4).
Figure 4-3 — Alternator Removal
[215 HB] FAN ASSEMBLY
Refer to Figure 4-4.
1. Loosen eight fan assembly mounting nuts
(2) and capscrews (1).
2. While supporting fan assembly (3), remove
nuts (2) from capscrews (1) and remove fan
assembly.
Figure 4-4 — Fan Assembly Removal
Refer to Figure 4-5.
3. If the fan assembly is equipped with a
viscous drive, be sure to store the assembly
either horizontally, with the fan face down
(hub flange up), or vertically, as shown in
Figure 4-5. This will prevent fluid leaking
from the assembly.
Do not store the assembly horizontally with the
fan face up (hub flange down). Fluid in the
viscous drive reservoir can leak out.
1. Drive belt
2. Adjusting capscrew
3. Capscrew
4. Mounting hardware
5. Alternator plate
6. Mounting nuts
7. Alternator
200349a
1
2
3
4
7
3
6
5
1. Capscrew
2. Nut
3. Fan assembly
200350a
2
1
3
5-101.bk Page 5 Friday, March 17, 2006 11:05 AM