User`s manual

If a message is setup for recording, the record LED will be

blinking and the message location will be displayed on the

Message Number Display, pressing this button will initiate the

recording process. Pressing it again, with the recording in

process, will stop the recording.

Pressing this button with no LEDs blinking and no message on

the Message Number Display will have no effect.

NOTE: Pressing and holding the Start/Stop button during

power up will set the configuration settings to their default

value. Applies to the DLY, PAS, PLY and 9,600 baud rate of

the MacFi-mpe.

2.3.6. Select Button

This button selects the message for recording or playing.

Depressing this button sequences through the individual

message positions, represented by the Message Number and

Status Display. The Select button may be used during record

setup or to initiate playback mode when the system is idle.

NOTE: Holding the Select Button during message select

causes the message number to increase by tens to

expedite navigating through the 99 messages.

2.3.7. Message Number and Status Display

These two seven segment LED’s indicate which message is

selected and provide a variety of status indications for the

MacFi-mp. See the table below for an explanation of the

different modes of the display.