User`s manual

Step 3 – Provide a maintained input signal between the

message activation input desired(Connector 1,

terminals 2-9) and common(Connector 1 terminal 1).

Both the Record and corresponding message on the

Message Number Display will remain solid during

recording

Step 4 – Start audio source.

Step 5 – Release message activation input to stop recording.

Step 6 – Release recording input to exit record mode.

3.3 Playing-Local

Local playback is achieved through the LED’s and buttons

located on the top of the MacFi-mp unit. Please reference the

Manual Button & LED Configuration section of this manual for

additional information on functions.

Step 1 – Make all desired power, audio out, configuration switch

and I/O connections to the unit and power up. Unit will

initiate self test and default to idle mode.

Step 2 – Use Select button to determine message location to

play. Select button will only increment between valid

message locations, showing them on the Message

Number Display. System will scan/blink through all

segments on the Message Number Display and exit if

no valid messages exist when Select button is

depressed.

Step 3 – Depress Start/Stop button to begin playback. Message

LED will remain solid during playback.

Step 4 – Depress Start/Stop button to end playback and return

to idle.

Playback message selection will time out after 1 minute of

inactivity. Default message is the first location with a valid

recording.

3.4 Playing-Remote Control

Remote Control playback is achieved through the I/O

connections located on the endplate of the MacFi-mp unit. This

process is only applicable to the first eight (1 - 8) messages on

the system. Please reference the Hardware Configuration

section of this manual for additional information on available

connections. Playback of message will include selected repeat

and delay parameters.