User Manual
DC16 Owner’s Manual
21
Power Connector
Push the locking multi-pin connector (at side up) of the power supply into the power connector of the
control surface. Push the line cord securely into the power supply and plug the other end into a grounded
AC outlet. These are included in the packaging.
Make sure that the AC power is matched to the AC power indicated on the rear panel
(below the power connector).
Warning: Disconnecting the plug’s ground pin is dangerous. Don’t do it!
In fact, it’s a bad idea to remove anything from – or add anything to, for that matter – the line
cord. Again, don’t do it!
Power Switch
Press the top of this rocker switch in to turn the DC16 on and
press the bottom
of this switch to turn it o.
As a general guide, the Wi-Fi router should be turned on rst,
then the DL32R followed by the DC16 and external power ampliers
or powered speakers. As such, the DC16 and DL32R should also
be turned o last. This will reduce the possibility of any turn-on
or turn-o thumps in the PA.
Technically the DC16 will still be able to discover the DL32R
even if the DC16 is powered on rst, but you might be required
to refresh the mixer list the DC16 received.
Lamp Input Jack
The 4-pin XLR connector located next to the power switch allows connection
of a 12V gooseneck lamp. Simply line up the pins and holes and push until
it locks – ‘clicks’ – in place.
There is sucient current provided to allow using high-intensity
[5 watt, 420 mA] halogen lamps.
The
Power
Block
Flat side (with arrows
and lines) on top.
Push to lock,
pull (on outlined area)
to unlock and remove.