User Manual

DC16 Owner’s Manual
56
Analog Controls
These three analog controls (located in the upper-right corner of DC16) allow you to raise and lower the
talkback, monitor and headphones levels. Because these are analog controls, they are NOT recallable.
• TALKBACK Knob
This knob controls the input level of the talkback mic with the gain ranging from a low of o (–∞)
up to a maximum of +10 dB. The talkback output level is set up via Master Fader’s Quick Access Panel.
Talkback may be routed to the main L/R, any subgroup, aux send and/or matrix
and is set up via Master Fader’s I/O patch.
• MONITOR Knob
This knob controls the level for the monitor bus with the level ranging from a low of o (–∞)
up to a maximum of +10 dB.
• PHONES Knob
This knob is used to adjust the volume from the phones output jack, from a low of o (–∞)
up to maximum gain (max) .
Warning: The headphone amp is loud and could cause permanent hearing damage.
Even intermediate levels may be painfully loud with some headphones. BE CAREFUL!
Always turn the phones knob all the way down before connecting headphones, soloing
a channel or doing anything new that may aect the headphone volume. Then turn it up
slowly as you listen carefully.
Analog Controls