User Manual

DC16 Owner’s Manual
61
Listed below is a quick overview of what you can expect over the next few pages, starting at the top
with iPad setup.
• iPad Setup – page 61
• Controllers – page 61
• DC16 Slot – page 62
• Position – page 62
• Follow Mode – page 63
• Follow Mode – page 63
• Current Selected Channel – page 63
• Selected Channel History – page 63
• Fixed View – page 64
• Advanced – pages 64-65
• Surface To Wireless Mixing – page 65
• Examples of Follow Mode – pages 66-69
• iPad Setup
The rst step here is to set up the iPads correctly. As seen in the image on the previous page, the main
iPad is located in the center position (connected to the CONTROL USB port on the rear panel of DC16).
On either side is a spot for an additional iPad (each connected to a CHARGING USB port, also on the rear
panel of DC16).
Please note that each iPad’s home button is located on the right hand side. You will almost
inevitably run into issues if the home button is on the left hand side. This is due to the
design of the iPad. The iPad controls – such as the up/down volume buttons, ringer on/o
switch and other controls – are located on the right hand side of the device which won’t
allow them to “sit” properly in the Smart Bridge.
• Controllers
There is some initial conguration that needs to occur on each iPad placed on the Smart Bridge
before moving on to the remaining sections. Each iPad’s behavior needs to be congured and this
setup takes place within Master Fader in Tools > Controllers. The rst thing you should see after
opening Tools > Controllers is displayed below.
DC16 Slot
Position
Follow Mode