User Manual
DL16S • DL32S Owner’s Manual
20
Appendix C : Rack Ear Installation Instructions
Introduction
Each DL6S and DL32S mixer arrives with one pair of rack ears set into the packing foam, visible upon opening the box.
It allows the mixer to be mounted in a standard 9" rack. A manual Phillips screwdriver is the only tool required for installation.
Procedure
() — Turn o the mixer and disconnect all cords. Place the mixer front side up / rear side down on a sof and dry flat surface.
(2) — Using the Phillips head screwdriver, remove the four screws, washers and corner pieces as shown below
and keep them in a safe place. You don’t need them now, but you may need them again someday.
(3) — Using only the new screws supplied, secure the rack ear brackets to each side of the mixer as shown below.
Hand-tighten the screws securely.
As seen above, the rack ears on the DL6S are the same size and interchangeable. In other words, both rack ears
work on either side of the mixer. The rack ears on the DL32S, however, dier in size. It is pertinent that you place
the “smaller” rack ear on the lef-hand side of the mixer (mixer front facing you); the “bigger” rack ear allows extra
space for the power cord and should be attached to the right side of the mixer.
Since we’re still discussing the DL32S, you should know that the side handle needs to be removed, as well.
This allows enough space for the mixer to be rack-mounted. Simply use the Phillips head screwdriver to remove
the two screws and keep them (and the handle) in a safe place. Like the screws and corner pieces from step 2,
you don’t need them now, but you may need them again someday.
(4) — Oer up the mixer to the rack and secure it in place with four rack screws (not supplied).