User Manual
DL16S • DL32S Owner’s Manual
5
Chapter 2 : DL6S and DL32S Side and Rear Panels
Introduction
The side panel of each DL6S and DL32S is oufitted with a power connector and power switch, while the Kensington Lock
resides on the rear panel.
Power Connector
This is a standard 3-prong IEC power connector. Connect the detachable
power cord (included in the packaging) to the power receptacle, and plug
the other end of the power cord into an AC outlet.
Make sure that the AC power is matched to the AC power
indicated on the side panel (below the IEC receptacle).
Warning: Disconnecting the plug’s ground pin is dangerous.
Don’t do it!
In fact, it’s a bad idea to remove anything from – or add
anything to, for that matter – the line cord. Again, don’t do it!
Power Switch
Press the lef side of this rocker switch in to turn the DL6S or DL32S
on and press the right side of this switch to turn the mixer o.
As a general guide, the DL6S • DL32S should be turned
on first, before any external power amplifiers or powered
speakers. As such, it should also be turned o last. This
will reduce the possibility of any turn-on or turn-o noises in the PA.
Kensington Lock
An optional Kensington Lock provides an extra level of security should the mixer be lef alone, unwatched. There are a wide
variety of cable apparatuses to choose from to secure your mixer via the Kensington Lock security slot. Feel free to decide on
what type works best for you by perusing the Kensington website: http://www.kensington.com/
While the Kensington cable and lock provide some level of security, it is NOT foolproof or guaranteed protection.
LOUD Audio, LLC. is not responsible for the loss, thef, damage or destruction of your mixer whether a Kensington
Lock has been used or not.