User Manual

Master Fader and My Fader Reference Guide
10
Network Connectivity
Now it’s time to connect to the network. Here are the steps to get some connectivity.
Connectivity before creativity!
(1) CAT5 Connection — Plug one end of the CAT5 Ethernet cable into the network connector on the mixer
and the other end into a LAN port on the router, NOT a WAN port. Read that sentence again.
(2) Power to the Router — The router needs to be powered up rst before anything else. Plug it in
and ip the power switch to the “on” position. <--ok, that might have been a cruel trick. Wireless routers
often power up when plugged in with no power switch to ip.
(3) The Waiting — Give the router a little time to boot up and do its thing. We know, we know,
the waiting is the hardest part. Somehow I don’t think Tom Petty was singing about wireless router
boot up times. This shouldn’t take more than 10-30 seconds.
(4) Power to the Mixer — Go ahead and power up the mixer.
Connect
At this point in time, we’re ready to dial in the settings of the iPad. Start by turning the iPad on
(if it’s not already).
You should have to follow these instructions only once for each iPad connected to the router.
After that they should connect automatically.
Tap “Settings” on the iPad.