User Manual

Master Fader and My Fader Reference Guide
164
I/O Patch
Introduction
Master Fader’s I/O patch allows you to patch audio from physical inputs to input channels and from
any signal source to any physical or recording output. To slide open the I/O patch view, just tap the
I/O patch button in the upper-right corner of the navigation bar. As seen in the images above and below,
it will illuminate green when open. We will go over the I/O patch of the DL32R rst (beginning below)
followed by the DL1608 and DL806 (starting on page 174).
I/O patch on DL32R
The DL32R I/O patch has six tabs. The horizontal rows are the sources and the vertical columns are the
destinations...the goal here is to connect a source to a destination. When rst opened, the I/O patch will
display the “Input A” tab and the default view will look something like this:
The source and destination may change, but the default patching for each channel input A is mic pres 1-32
routed to channels 1-32 and USB 1-4 routed to returns 1-4. Additionally, mic pre 32 is routed to talkback.
Drag anywhere in the black box to view these other routings.
Destination
Source