User Manual
Master Fader and My Fader Reference Guide
30
Input Routing
At the top of each channel strip is a thumbnail view of key input routing parameters for each
channel.
The screen shots to the left display the default settings of the digital trim...0.0 dB for those counting.
In addition to digital trim, the DL32R also displays the currently selected source [A or B], and if that
source is a mic pre, the corresponding mic pre gain and 48v setting.
Tapping a channel’s input routing button will change from the mixer view to that channel’s input
routing channel view.
There is quite a bit to learn about the input routing view. Check it out in chapter 9 starting on page 78.
EQ Curve
Next is a thumbnail of the current EQ and HPF processing that’s applied to each channel (whether the EQ
and/or HPF is currently engaged or not).
As seen below, there are ve possible scenarios regarding the EQ curve depending on whether the EQ
and/or HPF are enabled. Each one may look unique, but it is the same exact EQ in each of the ve dierent
scenarios.
Tapping a channel’s EQ curve will change from the mixer view to that channel’s EQ channel view.
To learn more about EQ and HPF, check out chapter 10 starting on page 83.
Gain Reduction Meters
The gain reduction meters display the input channel gain reduction from the gate [top]
and compressor [bottom]. These illuminate from right to left and are 20 dB when fully lit.
Tapping a channel’s gain reduction meter button will change from the mixer view to that
channel’s gain reduction meter channel view.
To learn more about dynamics, check out chapter 11 starting on page 93.
DL32R
DL1608
DL806
MODERN EQ OFF MODERN EQ ON MODERN EQ OFF MODERN EQ ON VINTAGE EQ ON/OFF
HPF OFF HPF OFF HPF ON HPF ON HPF ON/OFF